New Zealand Starlet Club

was just logging in to check everything as i do most days. The latest news on right side of page is as far back as 06, is it possible to note some of the recent happenings on this site, eg dyno day etc. To the average person who is not a user of this site it may look ancient and or not in use Just a...

is now going!!!!!!!! drives ok, got knock sensor problem causing it to go into limp mode but its going!!!!!

just required bit of engine start

cannot wait to sort the little niggly problems and tidyups

pics and videos to come!!!

was disgusted at how the red inlet manifold n stuff came out, looked crap so out came the matt black. Will change wastegate cap from red back to the silver one aswell still gotta touch up a few places but this is the general gist of it, bit more rewiring to be done aswell but sooo close to going now...

progress, only have cvs to plug in, the plug that goes in back of starter motor, sump gasket then fill with oil & water and set timing. also have to finish wiring up my gauges properly and get power steering bracket made up and bleed the clutch, few small things but shouldnt take even me long to do ...

im officially a slack cunt, been about 8 months since i blew head gasket and took off road, no wof and rego on hold and its till not going yet...getting there though decided against useing 4efte pistons, will keep with high compression, also havnt got head recond as i just want starlet going now, be...

havnt done much lately, have got a new flywheel, and had it lightened, also got a new pressure plate, been tidying up engine bay alot and fixing up all my dodgy wireing and removing everything that i dont need. http://i165.photobucket.com/albums/u66/xdrift_silvia/pressureplate.jpg http://i165.photob...

Well guys finally the correct motors arrived and ive spent the last couple nights after work swapping bits from 4efte over to the 5efhe im no mechanic or anything but have done all work myself with basic tools, except taking oil filter off, hands were too oily so flatmate took it off. still i bit mo...

I think it would be a great idea. Would give everyone a good idea on what parts to get and where and what to expect from it.